Engine Oil And Oil Filter Cartridge - Yamaha MT01X Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Engine oil and oil filter car-
tridge
The engine oil level should be checked
before each ride. In addition, the oil
must be changed and the oil filter car-
tridge replaced at the intervals speci-
fied in the periodic maintenance and
lubrication chart.
To check the engine oil level
1. Place the vehicle on a level sur-
face and hold it in an upright posi-
tion.
NOTE:
6
Make sure that the vehicle is positioned
straight up when checking the oil level.
A slight tilt to the side can result in a
false reading.
2. Start the engine, warm it up until
the engine oil has reached a nor-
mal temperature of 60 °C (140 °F),
let it continue to idle for ten sec-
onds, and then turn the engine off.
EAU36806
NOTE:
To achieve the proper engine oil tem-
perature for an accurate oil level read-
ing, the engine must have first
completely cooled down, and then
warmed up again for several minutes to
normal operating temperature.
3. Wait a few minutes until the oil set-
tles, remove the engine oil filler
cap, wipe the dipstick clean, insert
it back into the oil filler hole (with-
out screwing it in), and then re-
move it again to check the oil level.
1. Engine oil filler cap
NOTE:
The engine oil should be between the
minimum and maximum level marks.
1. Maximum level mark
2. Minimum level mark
3. Dipstick
4. If the engine oil is at or below the
NOTE:
When adding oil, be careful not to over-
fill the engine oil tank; the oil level rises
faster starting from the half level portion
on the dipstick.
5. Insert the dipstick into the oil filler
6-8
minimum level mark, add sufficient
oil of the recommended type to
raise it to the correct level.
hole, and then tighten the oil filler
cap.