BYD F0 Owner's Manual page 93

BYD AUTO
Before jack-up, please unscrew the wheel
bolts counterclockwise to loosen them. To
strengthen unscrewing, you can nest a
spanner into the bolt with its hanle on the
right, and grip the handle end to pull up (see
figure above). Please avoid the spanner
slipping out of the bolt.
Do not remove the bolts, just loosen them.
Friendly Tips
Do not use motor
lubrication oil on the bolts, or the
bolts will get loose to make the tire
drop off and cause serious accident.
4. Place the jack under the proper lifting
point, as shown in the figure.
Make sure that the jack is placed on the flat
and solid ground.
5. Height that allows installation of
spare tire.
oil or
Please notice that it needs larger clearance
to install the spare tire than remove the flat
tire.
For jack-up, please insert the jack handle
into the jack (loose joint) and rotate it
clockwise. When the jack touches the car
and starts lifting, please check again if the
jack is in the right position.
When the car is supported
completely by jack, no one is allowed
to stay under the car.
6. Remove the wheel bolts and replace
the tire.
Friendly Tips
F0 Owner's Manual
Take off the flat tire and put aside.
Roll the spare tire to the installation position,
aim the bolt hole at tire hole, and then screw
the tire bolt and fasten it (with a torque of
108 N·m).
Before installation, please brush off all
corrosive materials on the installation
surface with a wire brush. During the
90