Add Cleanser - BYD F0 Owner's Manual

BYD AUTO
You can pull out Model A fuse by the fuse
pulling tool. The location of the fuse
pulling tool is shown in the figure above.
If the fuse has been burned, you should
install a new fuse to the socket.
You should only install the fuse of the
amperage specifiedon the fuse box.
If there are no spare fuses, in emergency
situation, you can pull out the "DOME"
fuse which is dispensable in general
driving; if it has the same rating amperage,
it can be used as substitute temporarily.
If there is no fuse of the same amperage,
you should choose a fuse which has lower
amperage; and do try to get a fuse with the
amperage as close to the rating amperage
as possible. If you use the fuse whose
amperage is lower than the specified value,
it may be burned again, but this doesn't
mean it has a problem. You should install a
proper fuse as soon as possible, then put
back the substitute fuse in place.
You had better to keep a set of spare fuses
in the car for emergency use.
If the new replaced fuse is burned
immediately, the electrical system may
have problem. You should go to the
service store authorized by BYD for
repair.
Friendly Tips
Never use a fuse
amperage is higher than the rating
amperage or use any other objects to
replace the fuse, otherwise it may
cause serious damage and may lead
to fire.

Add cleanser

If the cleaner doesn't work, the
cleaner storage tank may have been
empty; you should check the cleanser
F0 Owner's Manual
liquid level on the storage tank. If the
level is lower, you should add cleanser.
whose
Pull open the storage tank cover before
adding the cleanser.
You can use water as cleanser. But in cold
regions where the temperature is below
freezing, you need to use the cleanser with
antifreeze. These products are available in
the service store authorized by BYD and
most auto parts stores. About the mixing
ratio with water, you can refer to the
instruction of the manufacturer.
Put back the cover of the storage tank after
adding the cleanser in it.
124