Check The Oil Level - BYD F0 Owner's Manual

BYD AUTO

Check the oil level

Max level
Min level
Proper
Add oil
When the engine is in the working
temperature, shut down the engine and
check the oil level by the oil level
dipstick.
1. To obtain the accurate reading，you
should park the car on flat ground.
Wait a few minutes after shutting
down the engine to let the oil
concentrate at the bottom of the
engine.
2. Pull out the oil level dipstick, place a
piece of cloth on its end and wipe it
clean.
Reinsert the oil level dipstick — try to
3.
insert it as deeply as possible,
otherwise the reading
inaccurate.
4. Pull out the oil level dipstick, place a
piece of cloth on its end and check the
oil level.
Please pay attention to not drip
the oil onto the parts of the car.
Too full
If the oil level is lower or slightly higher
than the Min oil level line, you should add
oil of the same type into the engine.
Remove the oil cover, add a small amount
of oil and check the oil level dipstick.
Repeat this process until the oil level is
close to the Max oil level line. We suggest
you to use funnel to add the oil.
After adding oil, the oil level shall be
between Min level line and Max level line
on the oil level dipstick.
When the oil level reaches the proper range,
please install the oil cover and screw it tight.
will be
Notice
F0 Owner's Manual
Notice
Please pay attention to not drip
the oil onto the parts of the car.
Avoid adding too much oil,
otherwise the engine
damaged.
When you finish adding the oil,
please check again the oil level on the
oil level dipstick.
The choice of oil
Please use the lubricants approved by the
service store authorized by BYD or the
same goods meeting the following grade
and viscosity.
Oil grade of gasoline engine:
SAE 5W—30 Above -30℃
SAE 10W-30/40
Above -15℃
API grade SG
above
Amount: 3 L
The specification of gear oil used by the
transmission:
will be
grade or
113