GE Profile 42 Owner's Manual And Installation Instructions page 39

12 CONNECT WATER SUPPLY
Check to make sure that Master Power switch
is in the O (OFF) position.
Refrigerator
Water Supply
• Locate and bring GE Smart Connect
to the front of the cabinet.
• Turn the water on to flush debris from line.
Run about a quart of water through tubing
into a bucket, then shut off water.
Copper Tubing
• Slip a 1/4" nut and ferrule onto end
of copper tubing. Insert tube into the union fitting
on the unit and tighten nut to union.
• Turn on the water to check for leaks.
GE SmartConnect Tubing
™
• Insert the molded end of the tubing
into the refrigerator connection. Tighten
the compression nut until it is just hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks.
• Turn on the water to check for leaks.
Note: Make sure excess tubing length does not
interfere with toekick installation.
Installation Instructions
House
Water Supply
tubing
™
39
13 TURN ON THE POWER
• Set the Master Power switch to the I (ON)
position.
• Check to make sure power to refrigerator is on
by opening refrigerator door to see if interior
lights are on.
Raise
Grille
Panel
Master
Power Switch
• The temperature controls are preset at 37°F
for the Fresh Food section and 0°F for the
Freezer section.
• Allow 24 hours to stabilize before making
adjustments.
Water Filter