Mitsubishi Electric SRK63HE-S1 User Manual page 19

Cooling/heating is affected by an air filter clogged up with dust etc., and the operation noise becomes louder. It may also
NOTE
use extra electricity. Please clean the air filter at appropriate intervals.
At the end of the season
1
Set the temperature setting for approximately a half
day at 30°C and perform the cooling operation.
Dry the inside of the unit.
2
Stop the unit and turn off the power switch.
The unit uses appr. 2W even when the power switch has been turned
off during the off-season for safety or for saving energy.
3
Clean and reinstall the air filters.
4
Clean both the indoor and outdoor units.
5
Remove batteries from the remote control.
Installing, inspecting, and replacing the natural enzyme filter and the photocatalytic washable deodorizing filter
• Installing the natural enzyme filter and the photocatalytic washable deodorizing filter
1. Open the air inlet panel and remove the air filters.
2. Install the filter holders, with the natural enzyme filter and the photocatalytic washable deo-
dorizing filter installed in the holders, in the air-conditioner.
3. Install the air filters and close the air inlet panel.
NOTE
The natural enzyme filter and the photocatalytic washable deodoriz-
ing filter may be installed on either the right or left side of the air-
conditioner.
• Inspecting and replacing the natural enzyme filter and the photocatalytic washable deodorizing filter
1. Open the air inlet panel and remove the air filters.
2. Remove the filter holders, with the natural enzyme filter and the photocatalytic washable
deodorizing filter installed in the holders, from the air-conditioner.
3. Remove the natural enzyme filter from the filter holder and inspect the filter. Use a vacuum
cleaner to remove any dust or dirt from the natural enzyme filter. Replace the natural enzyme
filter if it cannot be cleaned or if it has been used for about 1 year.
(The natural enzyme filter should be replaced after about 1 year of use. However, the actual
replacement period may vary depending on the conditions in which the filter is used.)
Remove the photocatalytic washable deodorizing filter from the filter holder and inspect the
filter. Periodically, remove any dust or dirt from the photocatalytic washable deodorizing
filter. If the photocatalytic washable deodorizing filter is particularly dirty, it may be washed
with water. However, the filter is fragile so be sure to wash it installed in the filter holder to
avoid damaging it. After washing the filter, place it in sunlight to dry. Placing the filter in
sunlight revitalizes the deodorizing effect.
(Do not dispose of the filter holders. They are reused.)
4. Install the natural enzyme filter and the photocatalytic washable deodorizing filter in the filter
holders, and then install the filter holders in the air-conditioner.
5. Install the air filters and close the air inlet panel.
For replacement natural enzyme filters and photocatalytic washable deodorizing filters, contact your dealer.
CAUTION
Do not expose natural enzyme filters to direct sunlight for an extended period. The bacteriolytic effect will be lost.
Item
Natural enzyme filter
Photocatalytic washable
deodorizing filter
Feature
By using the work of oxygen, mold and bacteria on the filter are
destroyed and the room air is kept clean.
Sources of odors on the filter are broken up, resulting in a deo-
dorizing effect.
At the beginning of the season
1
Make certain that there are no obstacles blocking the
air flow around the air intake and outlet openings of
the indoor and outdoor units.
2
Check the installation base for corrosion or rust.
3
Ensure that nothing has snapped and that the
earthed flex is not disconnected.
4
Ensure that the air filters are clean.
5
Turn on the power switch.
6
Insert batteries in the remote control.
– 18 –
Filter holder
Filter
Install Install
Color
Green
Orange