Sony KZ-32TS1U Training Manual page 35

Signal Name
Y
R-Y
B-Y
Signal Name
Out 0 +/- CN1204/pin 2, 3.
Out 1 +/- CN1204/pin 4, 5.
Out 2 +/- CN1204/pin 6, 7.
CLK Out +/- CN1204/pin 8, 9.
Out 3 +/- CN1204/pin 10, 11.
* The main digital signal level is shown, but there are ten spikes of power supply noise in the body of
the waveshape that are not shown, bringing the signal level to 6Vp-p. The noise is also present on the
TV screen when the rear shield is not installed.
Signal Name
Out 0 +/-
Out 1 +/-
Out 2 +/-
Out 3 +/-
FIGURE 12-2 - DIGITAL VIDEO OUTPUT WAVESHAPES TO THE PLASMA PANEL
Location of Digital Input Connector CN 1 on the Plasma Panel
Table 12-3 - Component Video Input
CN3002/pin 4
CN3002/pin 2
CN3002/pin 6
Table 12-4 - Digital Video Signal Output to Plasma Panel
From B Board
Waveshape *
+
-
10 usec/div. timebase
B Board
CN1204
FIGURE 12-3 - LOCATION OF DIGITAL VIDEO
SIGNAL CONNECTOR CN1
Location
To Plasma Panel
CN 1/pin 1, 3.
CN 1/pin 5, 7.
CN 1/pin 9, 11.
CN 1/pin 13, 15.
CN 1/pin 17, 19.
Signal Name
CLK Out
Approx. 30MHz
CN1 on the
plasma panel
33
12. Video Signal Flow
Signal Level
1.0p-p
0.8Vp-p
0.4p-p
Wire Color Signal Level *
Orange 0.7Vp-p
Yellow 0.7Vp-p
Pink 0.7Vp-p
Gray 0.7Vp-p
White 0.7Vp-p
Waveshape *