b) Seven connectors must be removed. Three connectors have a catch that must be pulled or squeezed to
separate the connector. The remaining four connectors are simply unplugged. Remove the conductive
mesh tape that shields the ribbon connector and unplug the white ribbon cable (Figure 9-3) by pulling it
straight out. Do not fold the ribbon cable.
Squeeze
Connector
Unplug
Connector
c) Remove the seven machine screws around the circuit board assembly and pull off the assembly.
d) Remove the rear shield with the top decorative panel to expose the circuitry (Figure 9-4).
Pull Catch
Squeeze
Connector
Connector
FIGURE 9-3 - REMOVE 7 CONNECTORS AND 7 SCREWS
B Board
FIGURE 9-4 - REAR SHIELD REMOVED
9. Plasma Panel Replacement - KZ-42TS1U
7 Machine
Screws
Power
Supply
24
Ribbon Cable
behind the tape
Circuit Board
Assembly