Sony KZ-32TS1U Training Manual page 19

The lower board assembly (behind the input jacks) must be removed because the plasma panel cannot be slid
out from underneath it. There is a lip under the board assembly that prevents the panel from being slid sideways.
c) Remove the input connector cover (four screws + VHF input jack)
TV
Board
Assembly
The TV boards are in an assembly held in by four black screws. Two can be easily seen at the right in Figure 8-
5. The left two are behind the plate. In the next three steps, you will lower the front Q board to remove all the
screws and pull out the H1 board cable harness from the assembly.
d) Remove two screws holding the front Q board in the TV board assembly (see Figure 8-5). Fold it down.
e) Remove the four black screws holding the TV board assembly. Gradually pull the assembly toward you.
f) Snake the H1 Board cable harness out the back to free the TV board assembly (see Figure 8-6).
Plate
Ÿ Remove the
Input Connector
Cover
2 Screws
Remove TV Board Assembly 1
Ÿ Fold Down board
Figure 8-5 - Remove TV Board Assembly 1
8. Plasma Panel Replacement - KZ-32TS1U
Input
Connector Cover
Figure 8-4 - Input Panel
17
Screw