Step 4 Ac Mains Lead Connection; Step 5 Preparing The Remote Control - Panasonic SC-PT170 Operating Instructions Manual

step 4 AC mains lead connection
To household mains socket
AC mains lead (included)
BE SURE TO READ THE CAUTION FOR THE
AC MAINS LEAD ON PAGE 4 BEFORE CONNECTION.
step 5 Preparing the remote control
Batteries
Insert so the poles ( and ) match those in the
remote control.
R6/LR6, AA
Replace the cover.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's
instructions.
10
This unit
AC IN
Press in and lift up.
Conserving power
This unit consumes a small amount of power, even when it
is in standby mode (approx. 0.2 W). To save power when
the unit is not to be used for a long time, unplug it from the
household mains socket.
You will need to reset some memory items after plugging in
this unit.
[Note]
The included AC mains lead is for use with this unit only.
Do not use it with other equipment. Also, do not use cords
for other equipment with this unit.
≥Use alkaline or manganese batteries.
≥Do not heat or expose to flame.
≥Do not leave the battery(ies) in an automobile
exposed to direct sunlight for a long period of time
with doors and windows closed.
Do not:
≥mix old and new batteries.
≥use different types of batteries at the same time.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage
which can severely damage the remote control.
Remove the batteries if the remote control is not going to
be used for a long period of time. Store in a cool, dark
place.
Use
Aim at the remote control signal sensor (
obstacles, at a maximum range of 7 m directly in front of
the unit.
39), avoiding