Installing and Connecting the LCD
Inserting Batteries into the Remote Control
The box contains your new LCD projection TV, a remote control and two
AAA batteries. No peripheral cables are included. If you intend to add
additional equipment to your LCD projection TV, please check the hookup
instructions for your desired setup before you begin. You may need to
purchase cables and/or splitters to complete the hookup properly.
Insert two size AAA batteries (supplied) by matching the + and – on the
batteries to the diagram inside the battery compartment.
Remove the batteries to avoid damage from possible battery leakage
whenever you anticipate that the remote control will not be used for an
Handle the remote control with care. Avoid dropping it, getting it wet, or
placing it in direct sunlight, near a heater, or where the humidity is high.
Your remote control can be programmed to operate most video
equipment. (See "Programming the Remote Control" on page 82.)