Sony KF-50XBR800 Service Manual page 69

4. Adjust the blue in the same manner.
Category
D-GM TPN 8
LCD-DR 12
LCD-DR 13
*
5. Write the data by pressing the [MUTE] + [ENTER] buttons on
the remote commander.
1. Enter the monoscope signal to the VIDEO 5 input, and set
the PICTURE MODE to "Vivid" and the WIDE MODE to
"Full".
2. Adjust the SUB BRT so that the borderline of 0IRE and
10IRE becomes distinctive.
Adjustment positions
Category Item
D-GM IM 2 SUB CON
D-GM IM 3 SUB BRT
*
3. If the SUB CON value was changed, check the white balance
and repeat adjustment to attain best sub brightness, sub con-
trast, and white balance.
4. After the adjustment finished, write the data by pressing the
[MUTE] + [ENTER] buttons on the remote commander.
Item Data
T-PATN RGB 4 (B)
B ODD VR ADJ*
B EVEN VR ADJ
Standard value
25*
20
1. Enter the RF monoscope signal.
2. Adjust so that the picture is displayed in the center of the
screen.
Adjustment position
Category Item
HV POS AD 0
1
3. Make sure that a difference in horizontal graduations is be-
low 0.1 frame, and a difference in vertical graduations is be-
low 0.1 frame, and then write the data by pressing the
[MUTE] + [ENTER] buttons on the remote commander.
1. Enter the RF signal, and press the [FAVORITES] button on
the remote commander.
2. Adjust so that the "Favorites" displayed on the right side of
the screen comes to the center of the display area.
Adjustment position
Category Item
OSD 1
3. After the adjustment finished, write the data by pressing the
[MUTE] + [ENTER] buttons on the remote commander.
H POS ADJ
V POS ADJ
HPOF