Sony KF-50XBR800 Service Manual page 16

By using remote commander (RM-Y910K), all circuit adjust-
ments can be made.
1. Pattern Generator (with component outputs)
2. Oscilloscope
3. Digital multimeter
1. Standby mode. (Power off)
2. DISPLAY t 5 t VOL (+) t TV POWER
on the remote commander.
(Press each button within a second.)
The following service screen will appear.
3D-COMB
NRMD
WSL: xxx
F/A FLAG: xxxxxxxx
CBA FLAG: xxxxxxxx
L001OUT
OCKPN
TEMP 42DEG
LCD PJ ENGINE
<LCD PROJECTOR ENGINE>
0 0 SERVICE
TV
0 0 G
VER.0.026
9/11
EE2F
1. The SCREEN displays the item being adjusted.
2. Press "1" or "4" on the remote commander to select the
adjustment item.
3. Press "3" or "6" on the remote commander to change the data.
4. Press "2" or "5" on the remote commander to select the category.
Every time you press "2" (Category up), Service mode
changes in the order as shown below.
5. If you want to recover the latest values press "-" then
"[ENTER]" to read the memory.
6. Press "[MUTING]" then "[ENTER]" to write into memory.
7. Turn power off.
Note: Press "8" then "[ENTER]" on the remote commander to
set the shipping conditions or turn set off and on to exit.
1. After adjustment, turn power off with the remote commander.
2. Turn power on and set to service mode.
3. Call the adjusted items again and confirm they were adjusted.