Installing And Connecting The Projection Tv; Contents; Inserting Batteries Into The Remote Control - Sony KP-46WT500 Operating Instructions Manual

01COV.book Page 10 Tuesday, July 30, 2002 3:46 PM

Installing and Connecting the Projection TV

Contents

Inserting Batteries into the Remote Control

10
Model name1[KP-46WT500] Model name2[KP-51WS500] Model name3[KP-57WS500] Model name4[KP-65WS500]
The box contains your new projection TV, a remote control and two AA
batteries. No peripheral cables are included. If you intend to add additional
equipment to your projection TV, please check the hookup instructions for
your desired setup before you begin. You may need to purchase cables and/
or splitters to complete the hookup properly.
Insert two size AA (R6) batteries (supplied) by matching the + and – on the
batteries to the diagram inside the battery compartment.
✍
Remove the batteries to avoid damage from possible battery leakage
whenever you anticipate that the remote control will not be used for an
extended period.
✍
Handle the remote control with care. Avoid dropping it, getting it wet, or
placing it in direct sunlight, near a heater, or where the humidity is high.
✍
Your remote control can be programmed to operate most video
equipment. (See "Programming the Remote Control" on page 68.)
e
E
e
E
[4-088-847-12]