Data Entry; Editing A Numeric Value; Selecting A New Setting From A List Of Choices; Table 10 - Three-Button Data Entry - Honeywell ST 700 User Manual

4.2.2 Data Entry

Data entry is performed from left to right. Select a character / digit by pressing  or  buttons, and
↵
then press to advance to the next character position to the right. Select the cross-hatch character
to terminate the entry or if the final character is already a space character, just press
All numeric entries are clamped at the low or high limit if needed. You can determine the low and
high limit for a parameter by selecting either the
the left-most digit and press
Screen
Symbol
Display the high limit for this parameter.
H
This symbol only appears in the left-most
position of the data entry field.
Display the low limit for this parameter.
L
This symbol only appears in the left-most
position of the data entry field.
<<
Terminate the numeric entry
0 thru 9, These characters are used to enter
Minus, numeric values. The minus sign only
Decimal appears in the left-most digit.
A thru Z,
0 thru 9
Not Available
special
symbols

4.2.3 Editing a Numeric value

Editing of a numeric value is a digit-by-digit process, starting with the left-most digit.
↵
1. Press to begin the edit process.
2. The Basic Display will show the current value of the item on the lower line, left justified. The
3. Press the  or  buttons to select the desired digit, and then press
digit to the right.
4. After the last digit has been entered, press ↵ one more time to write the new value to the
transmitter.

4.2.4 Selecting a new setting from a list of choices

Use the procedure described below to select a new setting for parameters that present a list of choices
(e.g., PV Display, Pressure Units, etc.).
↵
1. Press to begin the edit process.
a. The Basic Display will show the current setting of the item on the lower line, left
justified.
2. Press the  or  buttons to scroll through the list of choices.
↵
Press to make your selection. The new selection will be stored in the transmitter and will be
displayed on the lower line, right justified.
Revision 2.0
H
↵
button. The Display will show the selected limit.
Table 10 – Three-Button Data Entry
Numeric data entry
ST 700 Smart Pressure Transmitter User's Manual
or character while the cursor is positioned over
L
Not Available
Not Available
Terminate the text entry
These characters can be used to
enter the Tag ID
These characters can be used to
enter the Tag ID
<<
again.
Text entry
↵
to advance to the next
Page 27
▒