Commissioning; Over Temperature Shutdown; Purging; Automatic Switch Off - Redring Selectronic Premier Handbook

Over Temperature Shutdown

If an abnormal condition occurs which causes
the water to get too hot.
The unit will automatically shutdown
straight away and the water will stop
flowing. This is to prevent any hot water
coming out of the handset.
This is indicated by 8 short bleeps and the
display flashing a lowercase "o" and then "t"
(see Diagram 18). This will continue until the
water is at a safe temperature. The unit will
then switch off automatically and will need to be
restarted in the normal way (see "normal
operation" section)
It can take a long time for the unit to reach a
safe temperature. To speed this temperature
reduction up, the hot water can be purged
from the unit.

Purging

While the unit is in "o" (Over) "t"
(Temperature) shutdown mode. Press the
cooler button for more than 3 seconds. (See
Diagram 19)
This will switch the water on ONLY while the
button is pressed.
Caution!!
Water Will Be Hot
stand clear of the spray
from the handset.
Keep pressing the button the unit will then
switch off automatically with 3 short
bleeps when a safe water temperature has
been reached.
Temperature Lock Operation
This mode is selected on installation to
prevent the temperature being set too Hot or
too Cold. See section in 'Changing the
Operating Mode' Page 9.
All the controls are the same as previously
described.
However, the warmer and cooler adjustment
is locked to the digit range (Shown in table on
Page 9) and the temperature lock light will
come on (See Diagram 20).

Automatic Switch Off

With temperature lock selected, the shower
will automatically switch off after 30 minutes.
Near the end of the 30 minutes the shower will
Diagram 18
8
Audible Short Bleeps
Diagram 19
3
Audible Short
Bleeps
Diagram 20
Diagram 21
14

Commissioning

Ensure the water and electricity are switched
on to the unit.
Press and hold the Cooler button until
confirmed with one audible short bleep.
See Diagram 10
The digital display will illuminate with a capital
"C". See Diagram 11
If the button does not respond, ensure that the
flying lead from the PCB has been connected
to the front cover. See Diagram 6
Allow the unit to fill and wait for the water to
come out of the handset then press the
Stop/Start button turning the shower OFF
(Confirm with three audible short bleeps).
See Diagram 12
Re-start - Press Start /Stop Button in the
centre. (Confirmed with a single bleep) See
Diagram 12
Check that the outlet temperature increases to
a comfortable temperature.
Check for leaks.
Press START/STOP button to switch the unit
OFF (Confirm with three audible short
bleeps). See Diagram 12
This completes the commissioning.
IMPORTANT! This appliance is not intended for use by persons (including
children and the infirm) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their
safety.
I
Children should be supervised to ensure that they do not play with the appliance.
Warning! Do Not Switch The Shower On If You Suspect It Of Being Frozen,
Wait Until You Are SureThat It Has Been Completely Thawed Out.
Diagram 10
1
1
Audible Short
Audible Short
Bleep Bleep
Diagram 11
Diagram 12
3
Audible Short
Bleeps
11