Unipulse M252A Operation Manual page 33

4. For greater use of the printer
Current set value
This part is printed.
The following lines
are printed with "3".
About setting Nos.
Setting Nos. facilitate identification of each setting.
See detailed explanations of each setting or the appendix "Setting mode list"(page 80).
22
3.
Upon entry of the Automatic Print ON/OFF setting, the following is
printed. The current set value is indicated on the "NOW" line.
The current value is "Automatic Print ON".
Change the set value to "OFF".
To make the Automatic Print setting:
operating
To make other settings:
To end the setting mode:
For changing the set value, develop an input waiting state
with the
4.
Since the following is subsequently printed, change the set value.
To change
operating
Since the OFF set value No. is [0],
press [0] →
End --> ESC
Next --> Number-ENT
Change-> --> ENT
Now => ON
08:Automatic Print
--------------------------
>> Next is 08
[Setting No.] → [ENT]
[ESC]
[ENT] key.
> Input new number - ENT
End --> ESC
Next --> Number-ENT
Change-> --> ENT
Now => ON
08:Automatic Print
--------------------------
[Setting No.] → [ENT]
[ENT].
[ENT]