Try To Print; About Input Ch's - Unipulse M252A Operation Manual

3. Connecting with indicators

Try to print

The M252A prints when any of the following conditions are met.
1.
When the
2.
When No. 3 (PRINT) and No. 1 (COM) on the terminal block are short-circuited. (*)
3.
When an automatic print command is sent from the SI/F.
4.
When a print command is input to the RS-232C.
5.
At intervals set for interval print. (*)
* In the cases of 1, 2 and 5, the M252A does not print if no print data is input.

About input ch's

The M252A has two data input ch's. When using both ch's, select "8. Double print" or "9. Double print
with count" for [07: Print Every Format].
The following table shows input data to be printed.
・①
・②
・OP
・Single print ： When the [Print Every Format] setting is not "Double print".
・Double print ： When the [Print Every Format] setting is "Double print".
・Shaded part
Without OP
With OP
16
[ ]
PRINT key is pressed. (*)
： Data input to SIF Ach is printed.
： Data input to SIF Bch is printed.
： Data input to an option (BCD input or RS-232C) is printed.
： The alarm (buzzer) sounds.
See "Print data input ch's and alarm sound"(page 17) for details.
Input data
SIF Ach
SIF Bch
SIF Ach + Bch
SIF Ach
SIF Bch
SIF Ach + Bch
SIF Ach + OP
SIF Bch + OP
SIF Ach + Bch + OP
OP
Single print
Ach Bch
① ×
× ×
① ×
① ×
× ×
① ×
① ×
OP
×
① ×
OP
×
Double print
Ach Bch
① ×
× ②
① ②
① ×
× ②
① ②
① ×
OP
②
① ②
OP
×