Download Print this page

Guest 502-2 Installation And Operation Instructions Manual page 9

24 vdc spotlight with joystick control panel

Advertisement

2. Confirm that all wiring connections are accurate and that the spotlight is
connected to a 24 volt DC power source capable of supplying 10 amps even
when other accessories are operating. (See diagrams on pages 4 and 5.)
3. Check wiring connection, corroded crimps, for loose or corroded connections.
MOST PROBLEMS ARE CAUSED BY POOR WIRING CONNECTIONS.
4. If the spotlight does not move or light, remove the 4 bolts that fasten the
spotlight onto the mounting surface and gently lift the light until you can see
inside its base. Avoid cutting any wires. Inspect the visible wiring for loose or
broken connections. If there are signs of water damage, return the spotlight
and control to the Guest Service Department with information about how the
spotlight was installed. If there are no signs of damage, re-install the spotlight
and then replace the control pad.
5. If the spotlight moves properly but does not light, examine the halogen bulb.
Replace it if it appears discolored or broken. If the bulb appears normal, test
for a faulty relay by listening at the base of the light while someone activates
the bulb from the control panel. If no "click" is audible, or if a "chattering"
sound is heard, return the spotlight to the Guest Service Department for relay
replacement.
symptoms.
6. If the spotlight does not move in one direction only (that is: up, but not down or
left, but not right), and the connections are good, replace the control panel.
7. If the spotlight will not move left or right but operates normally otherwise, listen
at the base of the light while someone else moves the joystick to the left and
right. If the lower motor makes no sound when it is activated, replace the lower
motor.
If your light has a problem that is not described above, return the unit to the Guest
Service Department for a inspection. Be sure to include a brief description of the
problem, proof of purchase (if requesting warranty service), and your daytime
telephone and/or fax number.
Troubleshooting (Cont'd.)
NOTE: An inadequate power source may cause similar
8

Advertisement

loading

This manual is also suitable for:

503-2