Advertisement
Maintenance:
Under normal conditions, mild detergent and water will be sufficient to keep the
spotlight clean. Avoid using caustic chemicals or abrasives as they may damage
the housing. No lubrication is necessary.
Replacement spotlight bulb kit – 502-2
Replacement spot/flood bulb kit –
503-2
Joystick control -502-2
Joystick control - 503-2
Lower motor - (both 502-2 and 503-2)
Upper motor - (both 502-2 and 503 –2)
Relay PC board - (502-2)
Relay PC board - (503-2)
15' Extension Cable Kit (6-wire, blue wire not used on 502-
2)
NOTE:
THE CONTROL PANELS USED WITH OTHER GUEST MODELS WILL NOT
OPERATE THE MODEL 502-2 or 503-2.
Under normal use, your Guest Beamer spotlight will provide you with many years
of reliable service. If your unit should become damaged by a severe impact, we
recommend that you return the unit to our factory for reconditioning.
If an operational problem occurs:
1. Confirm that all fuses are intact. If a fuse has blown, do not replace the fuse
until the cause of the problem has been located and corrected.
replace a blown fuse with a higher value fuse.
Replacement Parts (24 volt)
(Available from The Guest Co.
See last page for contact information)
Item
Troubleshooting
7
Part #
729493
729494
22209-
24
22208-
24
U-3590
U-3589
U-3591
U-3588
729528
NEVER
Advertisement
