Advertisement
Silicone based sealants may cause damage to the foam gasket or the base of the
light.
7. Fasten the light securely to the mounting surface using four 1/4" diameter
(6mm) bolts, large flat washers, lock washers and nuts. Do not over tighten.
8. Install the gray 5-wire (model 502-2) or 6-wire (Model 503-2) cable between
the light and the planned location of the control panel. Avoid running the
cable across sharp edges or where it may be exposed to extreme heat. If
additional cable is needed, see page 7 for ordering information.
Mounting the Control Panel
1. Select a convenient mounting location for the control panel. Be sure that you
will have access to the area behind the location, and that you can drill holes
there without damaging existing wiring or structures. Do not place the control
where it could interfere with the safe operation of the vessel or vehicle. Avoid
mounting the control panel on a curved surface, or in a location that would be
exposed to direct rain or spray.
2. Use the template on the next page for measurements to make a hole for the
control panel.
CAUTION: Always wear eye protection when using power tools!
CAUTION!
2.25"
(57mm)
Control panel mounting cutout
1.5"
(38mm)
3
Advertisement
