Advertisement
Mounting the Spotlight
1. Select a flat, smooth surface to mount the light. Be sure that you will have
access to the underside of the location, and that you can drill holes there
without damaging existing wiring or structures. Avoid locations where lines,
anchors, sails or other hazards might cause damage to the light. Mounting
the light as far forward or as high as possible can help to reduce reflected
glare when the light is in use. It is recommended that you use marine grade
plywood for a back-plate.
2. Remove the foam gasket from the base of the light and use it as a template.
Note gasket orientation: Front mounting holes are further apart than the
rear holes Mark the location of the four corner holes and the center hole
squarely onto the mounting surface with pencil.
3.
Drill five 5/16"
marked points.
NOTE: Always wear eye protection when using power tools.
4. Return the foam gasket to the base of the light, making sure that all of the
wires exit through the center hole in the gasket.
5. Feed the wires from the base of the light through the center hole in the
mounting surface.
StarBrite® Boat Caulk #83801), can be applied to where the bolts and the
wires penetrate the mounting surface.
6. Place the light on the mounting surface, lens facing forward, and align the 4
holes in the light base and the foam gasket with the 4 corner holes drilled
into the mounting surface.
Installation
(7mm) holes through the mounting surface at the
A small amount of a non-silicone sealant, (such as
2
Advertisement
