Advertisement
3. Bring the 5-wire (Model 502-2) or 6-wire (Model 503-2) cable coming from the
spotlight out through the control panel, and make the connections as shown on
pages 4 and 5 for your model light.
4. Feed the spliced cable back into the cutout hole. Test fit the control panel and
use a pencil to mark the locations of the two small holes in the panel onto the
mounting surface. Remove the control panel, then drill a 3/32" (1mm) pilot
hole at each of the marked locations.
5. Apply a small amount of sealant, (such as StarBrite® Boat Caulk #83801), to
the back of the control panel face plate. Fit the control panel into the hole, and
fasten the control panel onto the surface with two # 8 x 3/4" (2mm x 1.5cm)
Phillips pan head self-tapping screws.
Electrical Connections
Guest models 502-2 and 502-3 have two types of wiring connections.
They are:
Power supply wires - the larger red (+) and black (−) wires that bring 24 volts
•
DC power to the light and to the control panel.
Control Cable wires - the small wires within a gray casing that carry your
•
commands from the control panel to the light.
DO NOT CONNECT THE POWER SUPPLY WIRES
These lights require a source of 24 volt DC power that is capable of supplying 10
amps of current. For best results, run two new wires from the red (+) positive and
black (−) negative power wires of the light directly to the main 24 volt DC
accessory panel. Install fuses as shown in the diagrams on pages 5 and 6. A 10
amp circuit breaker can be installed instead of an in-line 10 amp fuse.
If the light will be less than 30 feet (9M) from its power source, use 12 gauge
(3mm) wires. If the distance will be more than 30 feet (9M), use 10 gauge (5mm)
wires.
CAUTION!
TO ANY OF THE CONTROL WIRES.
DO NOT REVERSE THE RED (POSITIVE)
AND BLACK (NEGATIVE) POWER WIRES.
4
Advertisement
