Andrew ES45T Installation, Operation And Maintenance Manual page 18

Step 10
Use a carpenter's level to level support assembly as indicated in Figure 12. Loosen U-
bolts to move support assembly up or down as needed to achieve level surface.
Step 11
Tighten anchor bolts on rear pads and azimuth axis support base plate down using A-
325 procedure. See A-325 procedure for technique. (see page 12)
Step 12
Loosely attach elevation strut (P/N 49766) to azimuth axis joint (P/N 300746) as shown
in Figures 13 and 14.
•
Use ¾ x 3-½ in. bolt, lockwasher and nut
Figure 12
Figure 13
18
Installation Procedures