Step 7: Assemble Side Burner Cover & Igniter Module - Amana AM33LP-P Assembly, Installation Instructions And Use & Care Manual

Step 7: Assemble Side Burner Cover & Igniter Module
C
A
A. Side burner door
B. Side burner door handle
C. Phillips pan head screw
D. Hinges
E. Phillips sunken head screws
1. Remove the brass burner cap attached with tape along with side burner grate and set aside.
2. Remove the two (2) phillips pan head screws from the handle and use these screws to attach
the handle on the side burner door.
3. Use the supplied four (4) phillips sunken head screws to secure the two (2) hinges on the side
burner tray as shown.
4. Unscrew the igniter button cap and the plastic nut from the igniter module. Insert the neck of the
igniter module to the round hole on the shelf front face. Then use the plastic nut to secure the
igniter module in position. Install battery into battery compartment, negative (-) end in first. Screw
igniter push button cap on.
ASSEMBLY INSTRUCTIONS
B
G
H
I
E
D
F
F. 6 poles igniter module
G. Plastic nut
H. AA battery
I. Push button cap
E
D
19