Controlling Your Tv Or Av Amplifier (Receiver) With The Supplied Remote - Sony DVP-NC650V Operating Instructions Manual

You will hear one beep and the Sound
Feedback function is turned on.
To turn off the Sound Feedback
function
When there is no disc in the player, press and
hold II on the player for more than two
seconds. You will hear two beeps and the
Sound Feedback function is turned off.
Controlling Your TV or AV
Amplifier (Receiver) with
the Supplied Remote
By adjusting the remote signal, you can
control your TV with the supplied remote.
If you connect the player with an AV
amplifier (receiver), you can control the
volume with the supplied remote.
. Depending on the units being connected, you may
not be able to control your TV or AV amplifier
(receiver) using some of the buttons below.
* If you enter a new code number, the code number
previously entered will be erased.
* When you replace the batteries of the remote, the
code number you have set may be reset to the default
setting. Set the appropriate code number again.
Mng TVs with the remeb
E
2
TVtDVD
switch
Number
buttons
I .
-
l/c!)
VOL +I-
TV/VIDEO
WIDE MODE
ENTER
1
Slide the TV/Ml switch to "TV." $
2 Hold down I/&, and enter your TV's
z
manufacturer's code (see the table)
using the number buttons.
3
Release l/O.
continued +
73