Sony DVP-NC650V Operating Instructions Manual page 76

6 Press
D
on
the
player to start playing.
l
When the MEGA CONTROL button is lit, you
cannot use the Control Menu.
Playback starts and the display shows the
current disc and track numbers and the
playing time of the track. While the
MEGA CONTROL button on the front
panel is lit, you can control CD changer
with the controls on the player as follows:
To
Operation
Select a disc during
playback
Press the number
button on the remote
and ENTER, or */
* and ENTER
stop
Press
n
Pause
Press II
Resume play after pause Press II or D
Go to the next track or Press w
scene in continuous play
mode
Go back to the preceding Press w
track or scene in
continuous play mode
To
control
the
player again
Press MEGA CONTROL on the player.
The MEGA CONTROL button on the player
turns off and you can control the player.
l
Connect only a Sony 5/50/200/300/400 CD changer
to MEGA CONTROL jack.
l
Set CONTROL AI or CONTROL Al II in the setup
menu of the CD changer so that it matches the
connection made above. Refer to the operating
instructions supplied with the CD changer.
l
You cannot locate a particular point on a CD's track
using the controls on the player.
l
Depending on the CD changer, some controls on the
player may not operate the CD changer as they do
the player.
l
You cannot control the player when the MEGA
CONTROL button on the front panel is lit.
l
The player will not enter Resume Play after the
MEGA CONTROL button on rhe front panel has
been turned on and off.
l
You cannot control the CD changer right after
turning on the player or connecting the CD changer.
Wait a few seconds until the player recognizes the
CDs.
76