Using The Built-In Sampler - American Audio Velocity User Manual And Reference Manual

12. Using the Built In Sampler:
Your VelocityTM comes with an advanced built in sampler. You may store up to three samples on the three
FLASH BUTTON (30) (Once again please note you may only store either a CUE POINT or a SAMPLE into a
FLASH BUTON (30), not both). Your sample can be a maximum of 6.5 seconds in length. A sample can be
recalled while a CD is playing, while the CD drive is in PAUSE MODE, with the Flash StartTM function (see Flash
without music interruption. If you play your sample when the unit is already in playback mode your sample
will over lap the current music source. You can also play your sample once or in a continuous loop. As with
cue points you may store approximately 384 (128 x 3) samples in a drives memory (depending on available
memory).-The MEMORY BUCKET (57) on the LCD D/SPLAY (76) will approximate the remaining memory.
To create a sample:
1)
can not be stored as a sample and will automatically store as a Cue Point.
2) Press the MEMORY BU-TTON (72). The
MEMORY BU-ITON
indicating memory is ready to be stored.
4) The MEMORY BU-TTON (72) LED will turn off, when your sample is locked into memory.
5) At this point your sample has been stored into memory. The original loop you used to create the sample
will remain playing until the OUT BUTON (2) is pressed (Figure 26).
Figure 25
will glow red
6)Your sample can now be recalled at any time even when
Figure 27
loop is longer than 6.5 seconds it
3) Select one of the three FLASH BU7TON
press that button.
the unit is in PAUSE MODE. To recall a sample be sure the
sample function is on, by pressing the SAMPLE BUTON
(37) until the red sample button LED turns on. To play your
sample in a continues loop leave the sample function on.
To play your sample just once, turn the sample function off
immediately after initiating your sample. With the sample
function on, the sample will continue to play until the sample
function is turned off.
Sample Preview: A preview of the sample may also be
played at any time by pressing and holding down a FLASH
view function will only work if the original CD used to create
the sample is inserted in to the drive.
Important
out turning the sample function on, the FLASH BU-TTONS
If you try to activate your samples with-
Figure 25