User Preference Character Set; Initialization Message; A–3 Initialization Message - Digital Equipment DEClaser 1100 Series Service Manual

Table A–2 User Preference Character Set
User Preference
Character Set
DEC Supplemental
ISO Latin-1 Supplemental
JIS Katakana
ISO Latin-Hebrew
Supplemental
DEC Latin-Hebrew
Supplemental
DEC 7-Bit Hebrew
DEC Technical
1
Factory default setting
The initialization message is sent to connected devices (when the printer is
powered on or reset from the control panel) to indicate that the printer is
reinitializing. This feature is designed for use with future applications and
should be set to disable at this time. Consult the Digital ANSI-compliant
Printing Protocol level 3 Programming Supplement for additional information
about this feature.
Table A–3 Initialization Message

Initialization Message

Disabled
Enabled
1
Factory default setting
The DEClaser 1100 printer can identify itself as a Digital ANSI-compliant level
3 (DEC PPL3) printer, and therefore can be recognized as such by symbiont
and terminal drivers that conform to the Digital ANSI-compliant architecture.
This identification is also compatible with level 2 devices, since all level 2
sequences are also supported. You can also select an LN03 identification for
applications that require the printer to identify itself as an LN03 printer.
For example, the DECmate word processing system requires an LN03 device
identification. The device identification values are shown in Table A–4.
Value
1
00
10
20
30
40
50
60
Value
1
00
05
A.2 Macro Numbers
General Information A–3