Connecting The Power Cord - Pioneer AVH-X8650BT Owner's Manual

Chapter
27

Connecting the power cord

RGB cable (Supplied with Hideaway 1 seg digital TV tuner)
Hideaway 1 seg digital TV tuner
(GEX-1550DTV (sold separately))
Yellow
To terminal supplied with power regardless of
ignition switch position.
Red
To electric terminal controlled by ignition
switch (12 V DC) ON/OFF.
Orange/white
To lighting switch terminal.
Black (ground)
To vehicle (metal) body.
Note
When a subwoofer is connected to this
product instead of a rear speaker, change the
rear output setting in the initial setting. The
subwoofer output of this product is monaural.
White
Front speaker
Left White/black
Green
Rear speaker or
Subwoofer (4 Ω )
Green/black
When using a subwoofer of 70 W (2 Ω ), be sure to connect with Violet and Violet/black leads of this unit.
Do not connect anything to Green and Green/black leads.
Green
Not used.
Green/black
58
En
This product
Fuse (10 A)
Power supply
Power cord
With a two-speaker system, do not connect
anything to the speaker leads that are not
connected to speakers.
Gray
Front speaker
Gray/black Right
Violet
Rear speaker or
Subwoofer (4 Ω )
Violet/black
Violet
Subwoofer (4 Ω )
× 2
Violet/black
4 m
Microphone
antenna jack
Wired remote input
Hard-wired remote control adapter can be connected (sold separately).
Violet/white
Of the two lead wires connected to the back lamp, connect the one in which the
voltage changes when the gear shift is in the REVERSE (R) position. This connection
enables the unit to sense whether the car is moving forwards or backwards.
Yellow/black
If you use an equipment with Mute function, wire this lead to the Audio Mute lead on
that equipment. If not, keep the Audio Mute lead free of any connections.
Light green
Used to detect the ON/OFF status of the parking brake. This lead
must be connected to the power supply side of the parking brake
switch.
Blue/white
Power supply side
Connect to system control terminal of the
power amp (max. 300 mA 12 V DC).
Ground side
Parking brake
switch