Handling And Care Of Discs; Built-In Drive And Care - Pioneer AVH-X8650BT Owner's Manual

iPod
Message Cause
Error-02-6X/-9X/-DX iPod failure.
The iPod firmware version
Error-02-67
is old.
Bluetooth
Message Cause
The power failed for the
Error-10 Bluetooth module of this
product.
MirrorLink
Message Cause
The application list Failed to load the applica-
could not be read out. tion list.
There is no supported
No supported applications
application on your
can be found.
MirrorLink device.
Action
Disconnect the cable from the
iPod. Once the iPod's main menu
is displayed, reconnect the iPod
and reset it.
Update the iPod version.
Action
Turn the ignition switch to OFF and
then to ON.
If the error message is still dis-
played after performing the above
action, please contact your dealer
or an authorized Pioneer Service
Station.
Action
Disconnect the cable from the
smartphone, and then connect
the smartphone again after a few
seconds.
Turn the ignition switch to OFF and
then to ON.
If the error message is still dis-
played after performing the above
action, reset the smartphone.
If the error message is still dis-
played after performing the above
action, please contact your dealer
or an authorized Pioneer Service
Station.
Install MirrorLink compliant appli-
cations to your MirrorLink device.
Message Cause
Communication error There was a communica-
occurred.
tion error.
Launching the applica- Failed to launch the
tion failed. application.
Failed to display the
screen of your device
The image size is too large.
because of irregular
resolution.

Handling and care of discs

Some basic precautions are necessary when
handling your discs.

Built-in drive and care

Use only conventional, fully circular
discs. Do not use shaped discs.
Do not use cracked, chipped, warped, or
otherwise damaged discs as they may
damage the built-in drive.
Use 12-cm discs. Do not use 8-cm discs
or an adapter for 8-cm discs.
When using discs that can be printed
on label surfaces, check the instruc-
tions and the warnings of the discs.
Depending on the discs, inserting and
ejecting may not be possible. Using
such discs may result in damage to this
equipment.
Do not touch the recorded surface of the
discs.
Appendix
Action
Disconnect the cable from the
smartphone, and then connect
the smartphone again after a few
seconds.
Turn the ignition switch to OFF and
then to ON.
If the error message is still dis-
played after performing the above
action, reset the smartphone.
If the error message is still dis-
played after performing the above
action, please contact your dealer
or an authorized Pioneer Service
Station.
Try again.
The size of the images transferred
from the device exceeds 800 × 480.
Store discs in their cases when not in
use.
Avoid leaving discs in excessively hot
environments including under direct
sunlight.
Do not attach labels, write on or apply
chemicals to the surface of the discs.
Do not attach commercially available
labels or other materials to the discs.
— The discs may warp making the disc
unplayable.
— The labels may come off during
playback and prevent ejection of the
discs, which may result in damage to
the equipment.
To clean a disc, wipe it with a soft cloth,
moving outward from the center.
Condensation may temporarily impair
the built-in drive's performance. Leave
it to adjust to the warmer temperature
67
En