Sharp ZQ-2500 Operation Manual page 31

EXPENSE data transferred between the ZQ-2500/ZQ-2700
and the ZQ-1000 series is stored on the receiving unit
without payment type data.
When transferring EXPENSE data by mode from the
ZQ-1000 series to the ZQ-2500iZQ-2700, an "I/O DEVICE
ERROR" may occur. This will occur when there is not
enough memory space to be assigned as the area for
payment type data; EXPENSE data from the ZQ-1000
series does not have this space. If the error occurs, delete
unnecessary data on the ZQ-2500iZQ-2700 to increase the
amount of free memory, then transfer the data again. Once
an "I/O DEVICE ERROR" occurs, all EXPENSE data
transferred to the ZQ-2500/ZQ-2700 before the error is
cleared.
When transferring EXPENSE data by mode from the
ZQ-1000 series to the ZQ-2500/ZQ-2700, no data
verification can be carried out.
data
Transferring by mode or by entry
To transfer an entry,
Note: To perform mode transfer, select the mode by
pressing the mode key, and then press (CCE). It is not
necessary to display an entry.
2. Select the data transfer function on the receiver, and set it
26
in the receive mode by pressing (MENU], a then 2.
3. Select the data transfer function on the transmitter and
perform data transfer by pressing @, a, 2 then 1.
Notes:
Follow the same steps to transfer data from another ZQ or
l
an IQ series Organizer.
Notes described on page 25 also apply here.
l
Verification
Follow the steps explained in "Transferring data between
Transferring data with an EL series
Organizer (including Auto Dialer)
For the EL-6100 series Organizer, TEL data and SCHEDULE
data can be transferred. For the EL-6260 Auto Dialer, TEL data
can be transferred. Data is transferred by mode or by entry.
Data transfer restrictions
When transferring data with an EL series Organizer (including
the Auto Dialer), the following restrictions apply:
When transferring data to an EL series Organizer
Transferred data is added to previously stored data.
l