Sharp ZQ-2500 Operation Manual page 29

. Turn off the SECRET function on both the transmitter and
the receiver before mode transfer.
If the amount of memory available on the receiver at the
l
time of transfer is insufficient, data transfer is not possible.
The message "MEMORY FULL" appears. Delete any
unnecessary data, verify whether the available memory is
sufficient, and repeat the data transfer procedure.
. If an error message appears while transferring data, press
d a t a
Transferring backup
All the contents of the Organizer are transferred. During
backup data transfer, data stored on the receiver is deleted.
Proceed with caution. (Backup data transfer is only possible
between identical models.)
1. To select the data transfer function on the receiver and set
it in the receive mode for backup data transfer,
Press (MENU) (T] 2 (2ndl 2.
2. To select the data transfer function on the transmitter and
perform backup data transfer,
26
Press [MENV) (71 2 (nndl 1 Y.
data
Verifying
It is possible to verify data by mode by mode or entry. If any
discrepancies are found, the message "VERIFY ERROR" is
displayed.
To verify data in the SCHEDULE mode,
Select the mode on the transmitter and the receiver.
Press (SCHEDULEJ then (CCEI. (Transmitter)
l
Press (Receiver)
l
Press (MENU), [vl, 2 then 3 to set the receiver in the verify
mode.
Press (MENUJ, m then 2 to select the data transfer function
on the transmitter.
Press 1 to perform verification.
T O U N I T >
- V E R I F Y I N G -