Extron electronics MTP DA4 User Manual page 15

NOTE:
Pin 568 A Wire
1
2
3
4
RJ-45
Connector
5 White-blue
6 Orange
Side
Pins:
1 2 3 4 5 6 7 8
7
8
Pin 568 A Wire
Insert
Twisted
1
Pair Wires
2
3
4
5 White-blue
6
7
8
NOTE:
Figure 6.
TP Cable Termination
When the TP input is from a low resolution unit (MTP SV or MTP AV),
the signal assignment depends on the position of signal jumpers in
the transmitter and receiver (see the MTP AV Series User Guide).
Jumpers in Mono Position (Default)
568 B Wire Composite Video
Color Color MTP Signal
White- White- Reserved
green orange
Green Orange Reserved
White- White- Mono audio +
orange green
Blue Blue Video +
White-blue Video –
Green Mono audio -
White- White- Reserved
brown brown
Brown Brown Reserved
Jumpers in Stereo Position
568 B Wire Composite Video
Color Color MTP Signal
White- White- Video +
green orange
Green Orange Video –
White- White- Reserved
orange green
Blue Blue Audio left +
White-blue Audio left –
Orange Green Reserved
White- White- Audio right +
brown brown
Brown Brown Audio right –
If you are using Enhanced Skew-Free™ AV cable, use the
TIA/EIA T 568A standard only.
MTP DA4 and MTP DA8 • Installation and Operation
S-video RGB Video, MTP,
MTP Signal VTT/VTR Signal
Chroma (C) + Red/
V.Sync +
Chroma (C) – Red/
V.Sync –
Mono audio + Mono audio + or
RS-232 +
(MTP 15HD only)
Luma (Y) +
Luma (Y) – Green –
Mono audio – Mono audio – or
RS-232 –
(MTP 15HD only)
Reserved Blue/
H.Sync +
Reserved Blue/
H.Sync –
S-video
MTP Signal
Luma (Y) +
Luma (Y) –
Reserved
Chroma (C) &
audio left +
Chroma (C) &
audio left –
Reserved
Audio right +
Audio right –
9