How To Connect Your Receiver - OPENTEL ODT 4000V User Manual

3. HOW TO CONNECT YOUR RECEIVER

Please DO NOT plug in the main power supply cord until you
have finished all the connections.
1) LOCATION OF THE RECEIVER
Your receiver should be placed under proper ventilation.
Don't put in completely enclosed cabinet that will restrict the flow of air,
Resulting overheating.
The location should be safeguarded from direct sunlight, excess moisture,
rough handling or household pets.
Avoid stacking other electronic components on the top of the receiver.
The location should be safely accessible by the cable from your antenna
system.
2) CONNECTING THE RECEIVER WITH ANTENNA
Connect the coaxial cable to "ANTENNA" terminal marked at the rear of the
receiver.
All cable connectors should be finger tightened ; do not use any kind of
wrench on the cable over connectors.
The cable should be 75 Ω impedence coaxial twisted at the end with a
"IEC"type connector.
3) CONNECTING THE RECEIVER TO TV
To connect the receiver with your television, you can follow two methods ;
through RF cable, and through SCART cable.
Connect the RF cable to the terminal marked "TV OUT"at the rear panel of the
receiver and its other end to the TV RF input socket.
In the case of connecting your TV through SCART cable, connect the SCART
connector marked TV to respective SCART port in the TV.
4) CONNECTING YOUR VCR
To connect a VCR, the receiver has been provided with SCART at the rear
marked "VCR". Using a SCART connector, the VCR can be connected to the
receiver
4
HOW TO CONNECT YOUR RECEIVER
5) CONNECTING EXTERNAL AUDIO HI-FI SYSTEM
To connect any external Audio Hi-Fi system, the receiver has been provided with two
RCA connectors at the back of the receiver, marked with Audio L and R respectively to
connect the left and right Audio.
In case of Audio Hi-Fi system with digital audio input, please connect it to S/PDIF.
6) CONNECTING YOUR ANALOG RECEIVER
To facilitate the user using analog receiver to view analog channels,
the receiver has been provided with a loop through terminal marked as"LOOP OUT".
Connect the coaxial cable from this terminal to the IF input terminal of your analog
receiver.
Now by keeping the receiver in standby, you will be able to tune and view analog
channels from your analog receiver.
HOW TO CONNECT YOUR RECEIVER 5