OPENTEL ODT 4000V User Manual page 10

3. INSTALLATION
3. A. AUTOMATIC CHANNEL
16 MENU OPERATION
"Installation"menu helps you to
setup a variety of parameters
necessary for receiving signal, add
new service, upgrade the new
software and reset the channel
data.
Select "Installation"menu in main
menu, and you will be asked to
enter your PIN code.
You can find the following
"Installation"screen by entering it.
Your receiver includes the preprogrammed
information of transponders.
Select "Automatic Channel Search" menu in
"Installation" menu, and the following screen
will be displayed.
Select the desired transponder using the
"left/right" keys( ).
◀ ▶
·
Set "Channel no", "Channel Frequency",
"Search option" field to the appropriate value
using the left/right keys( ) or number key at
◀ ▶
·
each field.
Check the signal strength. Press "OK"key to start the "Automatic Channel Search"
procedure.
You can see the progressive status of channel searching.
Please note that the "Automatic Channel Search"procedure may take a few minutes.
Press the "menu"key or "exit"key to return to previous menu
In order to get the signal from other receiver instead of the antenna, set "Tuner 5V" option to
"Off". You can find "Tuner 5V" option in "Automatic Channel Search".
3. B. MANUAL CHANNEL SEARCH
It will be more convenient to use "Manual Channel Search"procedure when you want
to search channel for a specified
transponder. As in "Automatic Channel
Search", "Manual Channel Search"also
searches all channels broadcasted over a
specific transponder using its predefined
information. You can add a new
transponder if you cannot find it on the
predefined transponder list.
Select "Manual Channel Search"menu in
"Installation"menu, and the following
screen will be displayed.
17
MENU OPERATION