Table of Contents
Advertisement
Figure 1. Fitting the RF Switch Adapter
CHANGING THE RADIO'S ACCESSORY CONNECTOR COVER
1.
If the radio is fitted with a cover on the accessory connector,
remove this cover (refer to the User Guide for your radio). Failure
to remove the accessory connector cover may result in permanent
damage to the Digital Car Kit.
2.
Fit the accessory connector cover, delivered with the Digital Car
Kit, on the radio's accessory connector.
ADJUST THE BATTERY CONTACT BLOCK
The cradle can hold radios with different battery sizes. To adapt the
cradle for the battery size of your radio you may need to adjust the
battery contact block inside the cradle.
1.
Remove the crosshead screw located at the bottom of the cradle
(see figure 2).
2.
Lift up the battery contact block and remove it from the cradle.
3.
Insert the battery contact block in the appropriate alignment guides
(left and right) at the back of the cradle.
Use the front position for battery: PMNN4047
Use the rear position for batteries: PMNN4048, PMNN4049
Placing a radio in the cradle when the battery
contact block is not at the appropriate position for
the battery size being used may damage the cradle.
5
Advertisement
Table of Contents
