Table of Contents
Advertisement
2.0.1 Read these instructions very carefully before installing or using the projection
screen. This is importnat in order to use the product safely and to prevent
personal injury or other damage.
2.0.2 Electrical connections should be performed by a qualified electrotechnical
fitter (electrician).
2.0.3 Confirm that the circuits which will be worked on are completely voltage-free
before the electrical connections are made.
2.0.4 See the plate on the projection screen for information on voltage and
maximum power capability.
If you stand facing the screen, you will find the type plate on the lower left-
hand side of the back of the case.
2.0.5 If the projection screen is equipped with a pre-wired plug connection, the plug
must be accessible at all times.
2.0.6 The (wall) switch for the operation of the projection screen must be placed so
that the movements of the screen are visible, yet must remain out of the
range of the screen's moving parts.
2.0.7 The (wall) switch for the operation of the projection screen must be mounted
at least 1.5 meters from the floor.
2.0.8 The projection screen may not be hung so that when in the down position, it
blocks the view of signs indicating the location of the escape routes nor may it
block access to the escape routes themselves.
2.0.9 The projection screen may not be hung in front of an air shaft or air
conditioner.
2.10 When installing electrically operated projection screens, use either the wall
switch with automatic zero position which comes with the screen, or a
comparable type of switch. The latter switch should only be used after
consultation with a qualifed electrotechnical fitter (electrician).
2.11 Standard mounting materials used for hanging the projection screen are
supplied with the screen. Each situation should however be evaluated
individually to determine if the materials supplied are satisfactory or if they
should be adapted to the specific situation. For example in situations involving
loose stucco, walls in poor condition or wall systems. In case of doubt, consult
a structural engineer.
2.12 Make sure that the walls and the structural construction are sturdy enough to
be able to support the weight of the projection screen. In case of doubt,
consult a structural engineer.
2.13 For mounting on the wall or ceiling, in addition to the mounting materials
supplied, specially developed accessories are available for use with alternative
mounting methods. See also section 9 'Accessories'. For further information,
consult your supplier.
2.14 If you discover damage to the screen's wiring or case, discontinue the use of
the screen immediately and contact your supplier to repair the damage.
2. Safety information
T
T
EN
7
Hide quick links:
Advertisement
Table of Contents
