Projecta projection screens Instructions For Use Manual page 10

The screen must retract further into the case (top final stop):
• Turn the adjusting screw counterclockwise to the left 2 to allow the screen to
retract further. Use the hexhead screw wrench to do this (no. 4).
Important! If you allow the screen to retract too far, you risk damaging the screen and the
motor.
4.4.2. Electrical screens with built-in RF receiver
(Elpro RF electrol, Cinelpro RF electrol, Compact RF electrol,
Cinema RF electrol)
• Check the final setting.
1. Press the Down button to unroll the screen.
2.Press the Up button to retract the screen.
Changing the top final setting
1. Allow the screen to retract completely by pressing the Up button quickly
once (1) .
2. Keep the Up button and the Down button depressed for 5 seconds
simultaneously.
– The screen will retract and unroll quickly in confirmation.
3. Use the Up button and the Down button to secure the screen in the desired
new final position.
4. Keep the Stop button depressed for 2 seconds in confirmation.
Changing the bottom final setting
1. Allow the screen to unroll completely by pressing the Downbutton quickly once.
2. Keep the Up button and the Down button depressed for 5 seconds
simultaneously.
– The screen will retract and unroll quickly in confirmation.
3. Use the Up button and the Down button to move the screen to the desired new
final position.
4. Keep the Stop button depressed for 2 seconds in confirmation.
Programming an additional (second) remote control or wall transmitter
You can program an additional RF remote control or wall transmitter for operating
the screen.
Important! The Program button is located on the back of the remote control or wall
transmitter. Use a pen or paper clip to press the button.
1. Keep the Program button of the first remote control (already programmed)
depressed for 2 seconds.
– The screen will retract and unroll quickly in confirmation.
2. Press the program button of the extra remote control (still to be programmed)
quickly to program this for use.
Deleting the program of a remote control
If you have programmed a new remote control and would like to delete the old one,
for example if it is no longer functioning properly, you may delete the program from
the old remote control.
1. Keep the Program button of the newly programmed remote control depressed
for 2 seconds.
– The screen will retract and unroll quickly in confirmation.
2. Press the program button of the old remote control (to be deleted) quickly to
delete its program.
S
1 2
1 2 4
1 2 4
S
EN
13