Table of Contents
Advertisement
Complete the following steps to manually turn on the server:
1. Review the information in "Safety information" on page 163.
2. Turn on all external devices, such as the monitor.
3. Plug the server power cords into the power source.
4. Press the power-control button on the front of the server.
Turning off the server
Turning off the server refers to the act of disconnecting the server from the power
source.
Complete the following steps to manually turn off the server:
1. Review the information in "Safety information" on page 163.
2. See your operating system documentation for the proper procedure to shut
3. Press the power-control button on the front of the server. This will put the server
4. Disconnect the server from the power source.
Note: While the server is powering up, the power-on LED on the front of the
server is lit.
down the operating system.
Statement 5:
CAUTION:
The power control button on the device and the power switch on the
power supply do not turn off the electrical current supplied to the device.
The device also might have more than one power cord. To remove all
electrical current from the device, ensure that all power cords are
disconnected from the power source.
in Standby mode.
Note: You might need to press and hold the power-control button for more than
4 seconds to cause an immediate shutdown of the server and to force it
into Standby mode. You can use this feature if the operating system
stops functioning.
Note: After disconnecting all the power cords, wait approximately 15 seconds
for your system to stop running. Watch for the power-on LED on the front
of the server to stop flashing.
Chapter 1. General information
9
Advertisement
Table of Contents
