Mitre Table Lock; Bevel Lock; Bevel Adjuster; Clamp Assembly - 909 254CMS Instruction Manual

Mitre table lock

The mitre table lock (15) is
used to lock the table at the
desired mitre angle (Fig. E).
The mitre saw cuts from 0°
to 45° both left and right.
To adjust the mitre angle
loosen the mitre table lock
and depress the mitre lever
to allow the table to rotate,
rotate to the desired mitre
angle and lock the table in place. The mitre table features
positive click stops at 0°, 15°, 22.5°, 30° and 45° for quick
setting of common mitre angles.
WARNING. Be sure to tighten the mitre table lock before
making a cut. Failure to do so could result in the table
moving during the cut and cause serious personal injury.

Bevel lock

The bevel lock (7) is used to
set the blade at the desired
bevel angle (Fig. F). The
mitre saw bevel cuts from 0°
to 45° to the left. To adjust
the bevel angle loosen the
bevel lock. Adjust the saw
arm to the desired bevel
angle.
WARNING. Be sure to tighten the bevel lock before making
a cut. Failure to do so could result in the saw arm moving
during the cut and cause serious personal injury.
E
F

Bevel adjuster

To return the saw arm to the
vertical (0° bevel) position
move the saw arm to the left.
Return the saw blade to
the vertical position, it will
automatically stop at the 0°
bevel position. Tighten the
bevel lock.

Clamp assembly

The clamp assembly can be mounted to the fence, either
side of the saw blade, to suit the task at hand (Fig. H).
Use the clamp assembly lock (23) at the back of the fence
to secure the clamp assembly in position (Fig. I). (Fig. J).
(Fig. K).
H
J
11
G
I
K