HP Pavilion xz200 Service Manual page 73

Symptom Call Center:
Suggestions
If you cannot Set display resolution and
change the display color depth before starting
resolution or color DVD or video file player. You
depth while playing cannot change these settings
a DVD or a video once player is started.
file in AVI or MPEG
format
If a DVD or a video Before starting DVD or video
file in AVI or MPEG file player, press Fn+F5 to
format doesn't play switch to one display. You
with two displays cannot switch displays once
player is started.
If using both displays, DVD
or video image will not
appear on any display set up
as "secondary". Click Start,
Control Panel, Appearance
and Themes, Display. Click
Advanced on Settings tab,
then click S3Display tab and
change settings.
Display problems Notebook's S-video (TV-out)
while using a TV set port is optimized for DVD
as a monitor display. Performance may
vary when using S-video port
for other applications.
Before using TV set as
monitor, switch notebook's
display resolution to 800 by
600 pixels:
1. Connect video cable from
TV set to notebook's S-video
port.
2. Turn on TV.
3. Click Start, Control Panel,
Appearance and Themes,
Display, Settings, then click
Advanced button.
4. On S3Display tab, select
TV as Display Device, then
click OK.
5. Set screen resolution to
800 by 600 pixels, then click
OK.
Hard disk
Hard disk never Check power source.
spins.
Remove and reinstall hard
drive. Check connector.
Hard disk makes Back up drive immediately.
clunking or
Was notebook or drive
scratching noise.
dropped?
Hard disk makes Back up drive immediately.
buzzing or whining
Check hard drive installation.
noise.
Check for alternate noise
sources, such as PCMCIA
drive or fan.
3-10 Troubleshooting and Diagnostics
Repair Center: Repair Center:
Likely Causes Comments
Hard drive or If drive case is damaged,
connector. drive may not operate
properly.
Motherboard.
Hard drive. Check notebook and drive for
evidence of customer abuse.
Depends on source of
noise.
Technology Code IC)