Night Mode; Changing The Handset Name - Panasonic KX-TG7892AZ Operating Instructions Manual

Programming
3
Enter the desired date and month. a
MOKN
4
Set the desired time.
5
*: Select "AM" or "PM". a MOKN
6
MbN: Select the desired alarm tone. a
MSELECTN
R We recommend selecting a different
ringer tone from the one used for
outside calls.
7
MSELECTN a MOFFN
R When the alarm is set,
Note:
R To stop the alarm, press MOFFN or place
the handset on the base unit or charger.
R When the handset is in use, the alarm will
not sound until the handset is in standby
mode.

Night mode

Night mode allows you to select a period of
time during which the handset and/or base
unit will not ring for outside calls. This feature
is useful for time periods when you do not
want to be disturbed, for example, while
sleeping. Night mode can be set for each unit.
Important:
R Set the date and time beforehand
(page 16).
R If you have set the alarm, the alarm sounds
even if the night mode is turned on.
Turning night mode on/off
Handset
1
MMENUN#238
2
MbN: Select the desired setting. a
MSAVEN
R If you select "Off", press MOFFN to
exit.
3
Enter the desired hour and minute you
wish to start this feature.
4
*: Select "AM" or "PM". a MOKN
5
Enter the desired hour and minute you
wish to end this feature.
42
6
*: Select "AM" or "PM".
7
MSAVEN a MOFFN
R When the night mode is set,
Base unit
1
MMENUN#238
2
MbN: Select the desired setting. a
MSAVEN
R If you select "Off", press MEXITN to
is displayed.
3
Enter the desired hour and minute you
wish to start this feature.
4
MAM/PMN: Select "AM" or "PM". a MOKN
5
Enter the desired hour and minute you
wish to end this feature.
6
MAM/PMN: Select "AM" or "PM".
7
MSAVEN a MEXITN
R When the night mode is set,
Changing the start and end time
Handset / Base unit
1
MMENUN#237
2
Continue from step 3 for handset or step
3 for base unit, "Turning night mode on/
off", page 42.

Changing the handset name

Each handset can be given a customised
name ("Bob", "Kitchen", etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is "No". If you select
"Yes" without entering any handset name,
"Handset 1" to "Handset 6" is displayed.
Handset
1
MMENUN#104
2
Enter the desired name (max. 10
characters; see the character table,
page 30).
R If not required, go to step 3.
displayed.
exit.
displayed.
is
is