4. Removal of DSP P.C.B. (1)
a. Remove 2 screws ( u ) and remove the right Plate
Side in Fig. 2.
b. Remove 15 screws ( i ) and remove the right Upper
Frame in Fig. 2.
5. Removal of Main P.C.B. (2)
a. Remove 2 screws ( o ) and remove the left Plate
Side in Fig. 3.
a. Remove 6 screws ( ! 0 ) and then remove the left Side
Frame in Fig. 3.
Side Frame (L)
! 0
! 0
! 0
o
Plate Side (L)
Plate Side
(R)
MAIN (2)
! 0
! 2
Fig. 3
Note :
1.When the rear panel has been removed, the ground
wire of the input/output pin jack becomes loose.
Connect it to the chassis by using a lead wire.
DSP (1)
i
i
i
i
u
i
6. Removal of Main P.C.B. (3)
a. Remove 4 screws ( !1 ) and remove the center Upper
Frame in Fig. 4.
b. Remove 6 screws ( !2 ) and then take up the Sub
Chassis in Fig. 4.
Upper Frame
(center)
! 1
MAIN (3)
! 2
! 2
! 2
! 2
DSP-AX1/RX-V1
Upper Frame (right)
Fig. 2
! 1
! 1
Fig. 4
10