Advertisement
GB
12-12-2001
16:14
MODELS WITH A 24 HOUR TIMER (Fig. 4)
To programme the timer;
-
Check the time on your watch. If for example it is 10am, turn the number disc of the timer in a clockwi-
se direction until the number 10 on the disc lines up with the arrow head marker
The timer is normally supplied with all the teeth pushed into the centre allowing continuous operation.
To set the periods of time you would like the appliance to be off continue as follows;
-
Each tooth corresponds to a period of 15 minutes of time. Push the teeth with your thumbnail to the outer
rim of the timer. At this point, the sectors that correspond to the periods to be on and off will be visible.
-
Turn the appliance on and set it to the heat setting and temperature level on the thermostat that is required.
-
The heater will now function automatically everyday, switching on and off according to your selection.
(Important; the plug must always be inserted into the electrical socket and switched on)
-
To vary the programming times, simply return the teeth to their original position and set new periods of functioning.
-
If you desire to operate the heater without programming it, push all the teeth toward the centre (i.e. in
the mode as normally supplied)
-
To completely turn off the heater, turn off all the switches and remove the plug from the mains socket.
MAINTENANCE
Before carrying out any maintenance, unplug the heater from the mains and wait for it to cool. The convec-
tor requires no particular maintenance. It is sufficient to remove the dust with a soft, dry cloth. Never use
abrasive powders or solvents. If necessary remove concentrated areas of dirt with a vacuum cleaner.
WARNINGS
ATTENTION: in order to avoid any danger caused by an accidental resetting of the safety system, this
appliance must not be powered through an external timer.
-
Do not use the heater in the immediate surrondings of a bath, a shower or a swimming pool.
-
Never use the heater to dry laundry.
-
Never place the power cable on top of the heater while it is hot.
-
Only use the heater in an upright position.
-
Do not block the hot-air outlet grilles or the intake grille located on the bottom of the heater.
-
The heater must be positioned at least 50cm from furniture or other objects.
-
If the supply cord is damaged, it must be replaced by the manufacturer or it's service agent or a simi-
larly qualified person in order to avoid a hazard.
-
Do not use this appliance in rooms which have an area smaller than 4m
not place the heater in a draught, because strong draughts of air may adversely affect the equipment's
operational efficiency.
-
The heater must not be located directly below a socket-outlet.
-
IMPORTANT: Never for any reason cover the appliance during operation as this could lead to dan-
gerous overheating.
-
A safety device intervenes and turns off the appliance in the event of overheating or because the
appliance is positioned in a strong draught of air. To reactivate it, remove the plug from the electrical
outlet, allow the appliance to cool (about 5'), remove the cause of the overheating/draught and then
reconnect the appliance to the mains and turn it back on.
-
A number of models have a special device to cut off current if the unit is overturned, placed at an angle
or knocked, an acoustic warning indicates this problem.
-
The use of an extension lead is not recommended, as overheating of the extension lead may occur
during the operation of the heater.
-
As with any electrical appliance, whilst the instructions aim to cover as many eventualities as possible,
caution and common sense should be applied when operating your appliance, particularly in the vici-
nity of young children.
-
The appliance is not intended for use by young children or the infirm without supervision.
-
Young children should be supervised to ensure that they do not play with the appliance.
Pagina 4
on the time-clock.
. We recommend that you
2
5713002700/
11.01
Advertisement
