Go To Alarm Setup Interface; Alarm Setup - IC Realtime Forensic User Manual

Before operation, please make sure you have properly connected alarm devices
such as buzzer.

4.6.1 Go to alarm setup interface

In the main menu, from Setting to Alarm, you can see alarm setup interface. See
Figure 4-20.

4.6.2 Alarm setup

Alarm interface is shown as below. See Figure 4-20.
Alarm in: here is for you to select channel number.
Event type: there are two types. One is local input and the other is network input.
Type: normal open or normal close.
PTZ activation: Here you can set PTZ movement when alarm occurs. Such as go to
preset, tour& pattern when there is an alarm. Click "select" button, you can see an
interface is shown as in Figure 4-21.
Period: Click set button, you can see an interface is shown as in Figure 4-22. Here
you can set for business day and non-business day. In Figure 4-22, click set button,
you can see an interface is shown as in Figure 4-23. Here you can set your own
setup for business day and non-business day.
Anti-dither: Here you can set anti-dither time.
Show message: System can pop up a message to alarm you in the local host screen
if you enabled this function.
Send email: System can send out email to alert you when alarm occurs.
Record channel: you can select proper channel to record alarm video (Multiple
choices). At the same time you need to set alarm record in schedule interface (Main
Menu->Setting->Schedule) and select schedule record in manual record interface
(Main Menu->Advance->Manual Record).
Latch: Here is for you to set proper delay duration. Value ranges from 10 to 300
seconds. System automatically delays specified seconds in turning off alarm and
activated output after external alarm cancelled.
Tour: Here you can enable tour function when alarm occurs. It is a one-window tour:
Please go to chapter 5.3.9 Display for tour interval setup.
Please highlight icon
please click save button, system goes back to the previous menu.
to select the corresponding function. After all the setups
42