Table of Contents
Advertisement
Scope DataPage UHF MK2 Radio Paging System
Telephone Interface (models NDPDTMF and NDPLP only)
Numeric pagers
STEP 1:- CONNECT TO SYSTEM
DIAL PAGING SYSTEM EXTENSION NUMBER OR LINE PORT
WAIT FOR SIGN-ON TONES
STEP 2:- ENTER PAGER NUMBER (OR GROUP NO.) TO BE CALLED
TYPE (PAGER NUMBER)
TYPE
WAIT FOR ACCEPTANCE TONE OR PROCEED
STEP 3: ENTER NUMERIC MESSAGE TO BE SENT COMPRISING 0,1,2,3,4,5,6,7,8,9.
TYPE (NUMERIC DIGITS MAX 20)
TYPE
WAIT FOR SIGN OFF TONES
REPLACE HANDSET
REJECTED DATA IS SIGNALLED BY A SINGLE LOW BEEP, RE-ENTER DATA FROM STEP 2 OR
REPLACE HANDSET, WAIT FOR TIME OUT AND START AGAIN.
Advanced features
When proficient at using the system, you can speed up your paging by not waiting for the prompt tones,
simply enter the pager number
handset prior to hearing the sign off tones the page will be aborted. It is possible to send the page without
waiting for the sign on tones, this may well require the delay before sending the sign on tones to be
lengthened (see programming section on 'SET TIME BEFORE SIGN-ON TONES' ). To achieve this facility
you must send valid DTMF tones to be received by the system before the sign-on tones are generated. It is
therefore possible to extend the sign-on delay past the inactivity timer, which effectively means that the sign-
on tones will never be received.
Speed dialling
It may be possible to effect some speed dial functions with your telephone system, however telephone
exchanges vary as to the way in which they perform depending upon their own internal protocol. With
certain systems you may have to establish an audio connection with the port prior to sending the message.
With other systems it may be possible to programme pauses between accessing the port, sending the pager
number and sending the message. If this is possible, it will be necessary to extend the 'TIME BEFORE
SIGN-ON TONES' to allow valid data to be sent before receiving the sign-on tones.
Tone only paging
Numeric and alphanumeric pagers can receive tone only calls by entering
© Scope Communications UK Ltd, 2003 All Rights Reserved
DPMK2/6
Section 2
(THREE NOTES ESCALATING LOW TO HIGH)
(FOUR TONES HIGH,LOW,HIGH,LOW)
message
and listen for the sign off tones. If you replace the
13
(SINGLE MID TONE)
in place of the message.
07/05
Advertisement
Table of Contents
