Table of Contents
Advertisement
Scope DataPage UHF MK2 Radio Paging System
Telephone Interface (models NDPDTMF and NDPLP only)
Overview
IMPORTANT! For indirect connection to an internal PABX only. This unit must not under any circumstances
be connected direct to the PSTN.
The Scope digital paging interface can be used to transmit text or numeric messages from any telephone
connected to your exchange, direct to the pocket of the individual being paged. There are two types of
interface available, these cover all types of keyphone, hybrid and PABX systems with DTMF capability.
These can be supplied in two basic configurations:
1) ----LP. This interface connects to an external line port, it is supplied with a 50 volt supply to provide the
required voltage to the line port. This unit will work with any telephone system that can send DTMF to the
assigned port, without receiving a dial tone.
2) ----DTMF. This interface is only intended for use with systems dedicated to two wire ports. Access is
gained by dialling the extension number, the ringing will alert the system which will pick up the line. Use of
this interface with keyphones or hybrids of any sort is not recommended and we cannot provide any support
for such applications! Avoid any equipment with four wire capability!
Both of these interfaces contain BS6301 isolation devices. There is total electrical isolation between the
paging logic and power supply, and the PABX side of the apparatus.
Installation:
For interface type LP, the A and B wire of the external line port are connected to a 2/3a line jack on
terminals 2 and 5.
For the DTMF- PABX interface, use the lead provided to plug into a standard 2 wire extension socket as for
any (SLT) internal telephone.
Operation:
When the system leaves the factory, it will have been programmed with a default configuration which sets
up the system as follows:-
Number of pagers:
Default bleep type:
Password:
System Identity:
The system parameters can be changed and re-programmed via the keyboard, if required (see previous
section: Program Parameters, 3: Phone).
Your system has been programmed to be fully functional before leaving the factory, there is no need to
change any settings if you are happy with the factory settings.
DPMK2/6
Section 2
RANGES SET AS ORDERED
A
72765
REFER TO ORDER DOCUMENTATION
12
07/05
Advertisement
Table of Contents
