Table of Contents
Advertisement
30
30
86 87a
85
86 87a
87
87
Programmable Features - Total System Reset
Please See The Owner's Manual For Changing Programmable Features And
Programming Transmitters.
This security system has 23 features that can be programmed through the Features
Programming Mode. Changing individual features is explained in detail in the Owner's
Manual. However, a Total System Reset feature allows the installer, if needed, to quickly
return all 23 features to the factory-set default positions.
Green
Green
White
Red
Blue
Brown
Blue
85
Diagram
Violet
Page - 40
find partial ground through the wires that are connected to other circuits, but the alarm will
not function correctly, giving the impression of a defective control module. The alarm can
partially work, so a bad ground wire connection would be suspected. In some cases the
alarm could arm and disarm properly -but not function correctly otherwise.
Note: When power or ground is first applied the alarm will trigger "on" instantly.
Note: The Black wire attached to the control module is the antenna wire. Do not
connect this wire to anything or the transmitter's range will be reduced or eliminated.
Stretch the Black antenna wire out and as high as possible for the best operating range.
DLS
Red Wire - (Positive 12 Volt Input):
Constant Positive 12 Volts for security system's operation. When 12 Volts is first applied
to the Red wire, the system will activate, sounding the siren, flashing the lights and locking
the doors (if equipped with an optional doorlock interface). Note: In Valet Mode with the
ignition switch "on", this function will not work, allowing vehicle to be serviced without the
system being activated if the battery is disconnected and reconnected. The Red wire also
supplies 12 Volt Positive to the built-in relay for flashing the parking lights.
CONNECTION: Connect the Red wire to a Constant Positive 12 Volt source. This source
should have Positive 12 Volt, 15 Amp at all times and in all ignition key positions.
Connection locations can be at the supply wire at the ignition switch, the supply wire behind
the fuse block or the fuse/junction block. Never just insert the Red wire or any other security
system wire behind a fuse. Also, please note that connecting directly to the battery's Positive
terminal will expose this connection to failure due to a corrosive environment.
The Red wire's function is to supply
Page - 5
Continued Next Page
Advertisement
Table of Contents
