Violet Wire Connection - Positive Door Trigger; Blue Wire Connection - Negative Hood Trigger - Omega Research & Development K9-FIVEc Owner's Manual

VIOLET WIRE CONNECTION positive door trigger
VIOLET WIRE: (Door positive instant trigger wire): FUNCTION ONE: If violet wire
touches + 12 volt after the alarm has armed, the alarm will trigger. If the violet wire has
+ 12 volt at the time the alarm is armed from the transmitter, the circuit by-pass feature
will leave the violet wire circuit unprotected until the violet wire does not have + 12 volt.
FUNCTION TWO: For last door arming to work. After the ignition switch is turned
"off", the exit delay countdown will not begin until the violet wire changes from being
+ 12 volt to no + voltage (example: any door open, then the last door closes). Note: If
any door on this circuit is re-opened within the 30 second exit countdown, the countdown
will stop for as long as the door is open. Once the last door closes, the countdown resets
and 30 seconds later the alarm automatically arms itself. FUNCTION THREE: When
the alarm is triggered by the violet wire the L.E.D. light will start flashing (3 times &
pause) until the ignition switch is turned "On". CONNECTION: If factory dome light
pin switches are the positive type, connect the violet wire to a wire which is common to
all the door pin switches. NOTE: If the car has a delay dome light the circuit by-pass
feature will allow the alarm to armed from the transmitter instantly and will start
protecting the violet wire circuit when the dome light turns off. In passive arming mode,
the alarm arms 30 seconds after the dome light turns off. Test the target wire for + 12
volt when any of the doors are opened.
POSITIVE COURTESY LAMP SYSTEM
DOOR PIN SWITCH
ALARM BRAIN ALARM VIOLET WIRE CONNECTION TO DOOR
1 2 3 4
+ FROM FUSE BOX
1 2 3 4
+
1 2 3 4
1 2 3 4
1 2 3 4
DOME LIGHT
Page
-8
BLUE WIRE CONNECTION negative hood trigger
BLUE WIRE: (Hood, trunk and accessory negative instant trigger wire):
FUNCTION ONE: If the blue wire is grounded after alarm has armed, the alarm will trigger.
FUNCTION TWO: If the blue wire is grounded when the alarm is armed, the arming con-
firmation will change to 3 siren chirps and 3 light flashes to confirm that the circuit by-
pass feature will the blue wire circuit unprotected until it becomes ungrounded.
FUNCTION THREE: During "last door arming" exit delay time if the blue wire becomes
grounded the countdown timing will stop, resetting when the blue wire is ungrounded.
The alarm will arm automatically in 30 seconds later.
Note: If blue wire is grounded, then last door arming will not start until ungrounded.
FUNCTION FOUR: When alarm is triggered by the blue wire, the L.E.D. light will start
flashing (2 times & pause) until the ignition switch is turned "On" to clear it's memory.
CONNECTION: Connect to both hood and trunk self- grounding pin-switches for instant
Motion detectors and other detection devices can be connected to the
protection.
blue wire also. Diode-isolation may be required for some multiple sensor or pin-
switch applications.
ALARM
BLUE WIRE
BRAIN
Motion Detector Or
Optional Detectors
TRUNK PIN SWITCH
HOOD PIN SWITCH
Page
-9